231033 – Gearbox Reverse Stop Adjuster –
231033 – Gearbox Reverse Stop Adjuster –
Gearbox Reverse Stop Adjuster screw, part of the reverse gate mechanism in the manual gearbox gear-selection assembly. It sets and…
Gearbox Reverse Stop Adjuster screw, part of the reverse gate mechanism in the manual gearbox gear-selection assembly. It sets and…
Mainshaft Thrust Washer for the Series I and Series II gearbox assembly. This 0.135 in (135 thou) washer controls the…
Selector Shaft for the Series I, II, IIA, and III transfer case. This shaft is part of the transfer case…
Collar Bush for the four-wheel-drive selector mechanism in the two-speed transfer box. It seats on the high-range 4WD selector rod,…
Mudshield Output Shaft
Bolt – 5/16 inch BSF x 1 inch for the gearbox selector assembly. Used to secure the gear selector forks…
Bolt securing the gearbox to the transfer box in the drivetrain. This fixing clamps the main gearbox housing to the…
Screw
Transfer Box Sealing Ring – Locking Pin A rubber O-ring that seals the locking pin where it enters the transfer…
Mainshaft Thrust Washer – 2nd Gear (0.125″) is a selective shim located within the Series gearbox, fitted to control axial…
Thrust Washer – 0.128″ A gearbox mainshaft thrust washer for the second-speed gear, 0.128″ thick. It controls the end-float of…
Thrust Washer – 0.130″ A gearbox mainshaft thrust washer for the second-speed gear, 0.130″ thick. It controls the end-float of…
Thrust Washer for the 2nd gear assembly within the manual gearbox. Fitted to the mainshaft to control the end float…
Joint Washer for the LT76 manual gearbox. Fitted between mating faces within the gearbox to form an oil-tight joint on…
Intermediate Shaft
Transfer Box to Gearbox Mounting Stud, 2″ length, used to fasten the transfer case to the rear of the main…